GraphHopper не слушается велосипедом = нет

Question

я установил локальную копию GraphHopper вчера, но его результат не согласуется с демо-сервером, в частности, он маршруты через участки, обозначенные велосипедный = нет:

Моего сервера (неправильно): http://tile.miklcct.csproject.org:8989/?point=22.318106%2C114.162675&point=22.317262%2C114.156554&vehicle=bike&locale=en-GB&elevation=true&layer=MapQuest

Демо-сервер (справа): https://graphhopper.com/maps/?point=22.318106%2C114.162675&point=22.317262%2C114.156554&vehicle=bike&locale=en-GB&elevation=true&layer=MapQuest

config.properties

##### Vehicles ##### 
# 
# Possible options: car,foot,bike,bike2,mtb,racingbike,motorcycle (comma separated) 
# bike2 takes elevation data into account (like up-hill is slower than down-hill) 
# and requires enabling graph.elevation.provider below 
graph.flagEncoders=bike 

# Enable turn restrictions for car or motorcycle. 
# Currently you need to additionally set prepare.chWeighting=no before using this (see below and #270) 
# graph.flagEncoders=car|turnCosts=true 


##### Elevation ##### 
# 
# To populate your graph with elevation data use SRTM, default is noop 
graph.elevation.provider=srtm 
# 
# default location for cache is /tmp/srtm 
# graph.elevation.cachedir=./srtmprovider/ 
# 
# If you have a slow disk or plenty of RAM change the default MMAP to: 
graph.elevation.dataaccess=RAM_STORE 



##### Storage ##### 
# 
# configure the memory access, use RAM_STORE for well equipped servers, 
# MMAP_STORE_SYNC could be used otherwise but will be a lot slower 
graph.dataaccess=RAM_STORE 

# if you want to reduce storage size and you don't need instructions for the resulting path use: 
# osmreader.instructions=false 

#### Speed-up Mode vs. Flexibility Mode #### 
# 
# By default the speed-up mode with the 'fastest' weighting is used. Internally a graph preparation via 
# contraction hierarchies is done to speed routing up. This requires more RAM/disc space for holding the 
# graph but less for every request. Also only the first vehicle of the flagEncoders list will be prepared. 
# prepare.chWeighting=fastest 
# 
# Disable the speed-up mode (contraction hierarchies, CH) via enabling the flexibility mode: 
prepare.chWeighting=no 


##### Web ##### 
# if you want to support jsonp response type you need to add it explicitely here. By default it is disabled for 
# stronger security. 
# web.jsonpAllowed=true 

Как я могу правильно настроить его для соблюдения ограничений? Я использую последнюю ветвь мастера.

Answer 1

Я обнаружил, что это не проблема графического купепера. Проблема заключается в том, что я использовал источник данных из Гонконгского «metro extract», и я заменил его на карту Китая с geofabrik.de. Проблема была исправлена.